top of page
Wine Cellar Pod

INSTALLATION

​

Wine Cellar Pod - Installation - Concrete Slab

​

*Create a block work box in the floor slab area with a 15 cm concrete base 140 cm square ( internal ) by 75cm deep. Block and beam and floor voids follow the similar guidelines.

*Lay duct from this boxed area to an outside wall that will accommodate 3 x 3/4 inch pipes within it.

*Position cellar into the hole, so top edge is at, or just below calculated finished floor level.

*Back fill with dry mix sand and cement.

*Add mesh reinforcement and cap remaining surface area, then screed.

*Complete your finished floor surface (see A and B choices in detailed instructions )

*Remove builders protective cover and fit racks ( if not pre-fitted ) and mirror. (5 minutes)

*Lower the cellar lid into the opening and connect electric cable to transformer whilst doing so.

*Job complete.

* Images of more installations in both concrete floors and voids under timber floors can be found on the    gallery page & menu page headed - Fit in a Timber floor void.

​

 Detailed 112 Wine Cellar Pod Guidelines can be forwarded upon request.

​

 We now also distribute 28 and 56 bottle space saver cellars, contact us for more details and prices.

 



Email: admin@winecellarpod.co.uk

​

20210224_124428.jpg
20210309_154759.jpg
20210616_143347.jpg
Unknown-1.jpeg
20210623_131628.jpg
UNDERGROUND WINE CELLAR KITCHEN.jpeg
wine cellar1[2][2] (1).jpg
wine cellar 3[2][2].jpg
wine cellar 4[2][4].jpg
wine cellar 5[2].jpg
Wine Cellar Pod

Wine Cellar Pod - Installation - Floor void timber floor

bottom of page